Best Pool Cover Pumps

Best Pool Cover Pumps

What is a Pool Cover Pump?

A pool cover pump is a device that is used to remove water from a pool cover. Pool covers are used to keep debris out of pools, but they can also collect water, which can weigh down the cover and make it difficult to remove. Pool cover pumps help to keep the cover clean and free of water, so that it can be easily removed and replaced.

Types of Pool Cover Pumps

There are two main types of pool cover pumps: submersible and surface. Submersible pumps are placed in the water below the pool cover, while surface pumps are placed on the deck or patio next to the pool.

Submersible Pool Cover Pumps

Submersible pool cover pumps are the most common type of pool cover pump. They are easy to install and operate, and they are very effective at removing water from pool covers. Submersible pumps are typically powered by electricity, but there are also some models that are powered by solar energy.

Surface Pool Cover Pumps

Surface pool cover pumps are less common than submersible pumps, but they can be a good option for pools with limited space. Surface pumps are typically smaller and lighter than submersible pumps, and they are easier to move around. Surface pumps are also typically less expensive than submersible pumps.

Features to Consider When Choosing a Pool Cover Pump

There are a few factors to consider when choosing a pool cover pump, including:

  • Flow rate: The flow rate is the amount of water that the pump can remove from the pool cover per hour. Choose a pump with a flow rate that is sufficient for the size of your pool.
  • Power source: Pool cover pumps can be powered by electricity or solar energy. Choose a pump with the power source that is most convenient for you.
  • Weight: Pool cover pumps can be heavy, so choose a pump that is easy to move around.
  • Price: Pool cover pumps can range in price from a few hundred dollars to several thousand dollars. Choose a pump that fits your budget.

How to Install a Pool Cover Pump

The installation process for a pool cover pump will vary depending on the type of pump you choose. However, the basic steps are the same for all types of pumps.

  1. Choose a location for the pump. The pump should be placed in an area where it will not be exposed to direct sunlight or rain.
  2. Dig a hole for the pump. The hole should be large enough to accommodate the pump and its cord.
  3. Place the pump in the hole. Make sure that the pump is level.
  4. Fill in the hole around the pump. Tamp the soil down firmly.
  5. Connect the pump to the power source.
  6. Turn on the pump.

How to Maintain a Pool Cover Pump

Pool cover pumps should be maintained on a regular basis to ensure that they operate properly. The following are some tips for maintaining a pool cover pump:

  • Clean the pump filter regularly. The filter should be cleaned at least once a week.
  • Check the pump for leaks. If you see any leaks, repair them immediately.
  • Store the pump in a cool, dry place when it is not in use.

By following these tips, you can keep your pool cover pump in good working condition for years to come.

Leave a Reply

Your email address will not be published. Required fields are marked *